Pioneer 1020 Naming station presets, Listening to station presets, Abcdefghijklmnopqrstuvwxyz

Basic playback

2 Press T.EDIT (TUNER EDIT).

The display shows PRESET MEMORY, then a blinking memory class.

3Press CLASS to select one of the seven classes, then press PRESET / to select the station preset you want.

You can also use the number buttons to select a station preset.

4Press ENTER.

After pressing ENTER, the preset class and number stop blinking and the receiver stores the station.

Naming station presets

For easier identification, you can name your station presets.

1Choose the station preset you want to name.

See Listening to station presets below for how to do this.

2Press T.EDIT (TUNER EDIT).

The display shows PRESET NAME, then a blinking cursor at the first character position.

3 Input the name you want.

Choose from the following characters for a name up to eight characters long.

ABCDEFGHIJKLMNOPQRSTUVWXYZ

abcdefghijklmnopqrstuvwxyz

0123456789

!”#$%&’()∗+,–./:;<=>?@[ \ ]^_{} ˜ [space]

Use /to select a character, /to set the position, and ENTER to confirm your selection.

Tip

•To erase a station name, simply repeat steps 1 to 3 and input eight spaces instead of a name.

•Once you have named a station preset, you can press DISP when listening to a station to switch the display between name and frequency.

05

Listening to station presets	English
you haven’t done this already.
You will need to have some presets stored to do
this. See Saving station presets on page 48 if
1 Press TUNER to select the tuner.
2 Press CLASS to select the class in which	Deutsch
the station is stored.
Press repeatedly to cycle through classes A to G.
3 Press PRESET / to select the station
preset you want.
• You can also use the number buttons on	Français
the remote control to recall the station
preset.
	Italiano
	Nederlands
	Español

49

En