Controlling the rest of your system 09
81
En
English Français
Deutsch
Nederlands
Italiano Español
5 Repeat steps 3 to 4 to program a
sequence of up to five commands.
If you press R.SETUP before programming is
completed, commands programmed up to that
point will be stored.
6 Press
R.SETUP
to exit the programming
mode.
Using multi operations
1 Press
MULTI OPERATION
.
The LED flashes continuously.
2
Within five seconds, press
an input
function button that has been set up with a
multi operation.
The receiver switches on (if it was in standby)
and the programmed multi operation is
performed automatically.
Using System off
1Press
MULTI OPERATION
.
The LED flashes continuously.
2
Within five seconds,
press
SOURCE
.
The command sequence you programmed will
run, then all Pioneer components will switch
off1, followed by this receiver (switch of all the
zones becomes off).
Erasing all the settings for the multi-
operation
This erases all the settings programmed in the
remote control for the multi-operation.
1 Press and hold the
R.SETUP
, press “8” for
three seconds.
The LED flashes continuously.
• To cancel the preset setup mode press
R.SETUP.
2 Press the input function button
containing the program you want to cancel or
the
SOURCE
button for three seconds.
If the LED lights for one second, the erasing
has been successfully completed.
Note
1 In order to avoid accidently switching off a DVD recorder that is currently recording, no DVD recorder power off codes
are sent.
VSX-1020_UC.book 81 ページ ２０１０年１月７日 木曜日 午後６時０分