Pioneer 1020 manual Direct function, Erasing all learnt settings that are in one input function

Controlling the rest of your system 09

Erasing all learnt settings that are in one input function

This operation erases all the operational settings of other devices that have been programmed in one input function, and restores the factory default.

This function is handy for erasing all data programmed for devices no longer being used.

1Press and hold the R.SETUP, press “9” for three seconds.

The LED flashes continuously.

•To cancel the preset setup mode press R.SETUP.

2Press and hold the input function button corresponding to the command to be erased for three seconds.

If the LED lights for one second, the erasing has been successfully completed.

Direct function

• Default setting: On

You can use the direct function feature to control one component using the remote control while at the same time, using your receiver to playback a different component.

This could let you, for example, use the remote control to set up and listen to a CD on the receiver, and then use the remote control to rewind a tape in your VCR while you continue to listen to your CD player.

When direct function is on, any component you select (using the input function buttons) will be selected by both the receiver and the remote control. When you turn direct function off, you can operate the remote control without affecting the receiver.

1Press and hold the R.SETUP, press “5” for three seconds.

The LED flashes continuously.

•To cancel the preset setup mode press R.SETUP.

2Press the input function button for the component you want to control.

3Press “1” (On) or “0” (Off) to switch direct function.

If the LED lights for one second, the setting has been successfully completed.

If the LED flashes three times to indicate, the setting has failed.

4 Press R.SETUP to exit the setup.

English Deutsch Français Italiano Nederlands Español

79

En