Pioneer 1020 manual If the connections were right, select GO Next and continue, Enter

Basic Setup 04

4Press RECEIVER and then select START.

5Follow the instructions on-screen.

Make sure the microphone is connected, and if you’re using a subwoofer, make sure it is switched on and set to a comfortable volume level.

6Wait for the test tones to finish, then

confirm the speaker configuration in the GUI screen.

A progress report is displayed on-screen while the receiver outputs test tones to determine the

speakers present in your setup. Try to be as quiet as possible while it’s doing this.1

If no operations are performed for 10 seconds while the speaker configuration check screen is being displayed, the Auto MCACC Setup will resume automatically. In this case, you don’t need to select ‘OK’ and press ENTER in step 7.

•With error messages (such as Too much ambient noise! or Check microphone.) select RETRY after checking for ambient noise (see Problems when using the Auto MCACC Setup on page 40) and verifying the mic connection. If there doesn’t seem to be a problem, you can simply select GO NEXT and continue.

	1a.Full Auto MCACC
	A/V RECEIVER
Now Analyzing...		2/9
Environment Check
Ambient Noise		: OK
Microphone		:
Speaker YES/NO		:
			1a.Full Auto MCACC
	L	:	A/V RECEIVER
			YES
Exit	FHL	:	YES	Cancel
	C	:	YES
	FHR	:	YES
	R	:	YES
	SR	:	YES
	SBR	:	YES
	SBL	:	YES
	SL	:	YES
	SW	:	YES
	10	OK	RETRY
	Exit			Cancel

The configuration shown on-screen should reflect the actual speakers you have.

•If you see an ERR message (or the speaker configuration displayed isn’t correct), there may be a problem with the speaker connection.

If selecting RETRY doesn’t work, turn off the power and check the speaker

connections. If there doesn’t seem to be a problem, you can simply use /to select the speaker and / to change the setting and continue.

•If Reverse Phase is displayed, the

speaker’s wiring (+ and –) may be inverted. Check the speaker connections.2

–If the connections were wrong, turn off the power, disconnect the power cord, then reconnect properly. After this, perform the Full Auto MCACC procedure again.

–If the connections were right, select GO NEXT and continue.

7Make sure ‘OK’ is selected, then press

ENTER.

A progress report is displayed on-screen while the receiver outputs more test tones to determine the optimum receiver settings for Channel Level, Speaker Distance, Standing Wave and Acoustic Cal EQ.

Again, try to be as quiet as possible while this is happening. It may take 3 to 10 minutes.

8The Auto MCACC Setup procedure is

completed and the Home Menu menu reappears automatically.3

Be sure to disconnect the microphone from this receiver upon completion of the Auto MCACC Setup.

English Deutsch Français Italiano Nederlands Español

Note

1 Do not adjust the volume during the test tones. This may result in incorrect speaker settings.

2 If the speaker is not pointed to the microphone (listening position) or when using speakers that affect the phase (dipole speakers, reflective speakers, etc.), Reverse Phase may be displayed even if the speakers are properly connected.

3You can also choose to view the settings from the MCACC Data Check screen. See Checking MCACC Data on page 95 for more on this.

39

En