FRONT(front speakers)—CENTER (center
speaker)—REAR(rear speakers)—
SUBWOOFER (subwoofer)
4 Touchcor dto select cross-over fre-
quency.
Eachtime you touch cor dselects cut-off fre-
quenciesin the following order:
63—80—100—125—160—200(Hz)
Note
Selectinga cross-over frequency is to set a cross-
overfrequency of the subwoofer ’s L.P.F.(low-pass
filter)and that of the SMALL speaker H.P.F.(high-
passfilter). The cross-over frequency setting has
noeffect if the subwoofer is set to OFF and other
speakersare set to LARGE or OFF.
Adjusting the speaker outputlevels
Speakerlevel can be adjusted finely by listen-
ingto an audio output. First, use test tone to
adjustthe approximate speaker level, and then
usethis function to adjust finely.
1 TouchNEXT on the DSP function menu.
2 TouchSP LEVEL.
3 Touchaor bto select the speaker to
beadjusted.
Eachtime you touch aor bselects the speak-
erin the following order:
FRONT-L(front speaker left)—CENTER (center
speaker)—FRONT-R(front speaker right)—
REAR-R(rear speaker right)—REAR-L (rear
speakerleft)—SUB WOOFER (subwoofer)
#Youcannot select speakers whose size is set
atOFF.
4 Touchcor dto adjust the speaker out-
putlevel.
Eachtime you touch cor dincreases or de-
creasesthe speaker output level. +10 to –10 is
displayedas the level is increased or de-
creased.
Notes
!Youcan also display the speaker setting menu
bypressing BOOST button.
!Toadjust the speaker output levels in this
modeis the same as making the speaker out-
putlevels at TEST TONE. Both provide the
sameresults.
Adjusting the speaker outputlevels using a test tone
Thisfunction allows you to easily get the over-
allbalance right among the speakers.
1 TouchNEXT on the DSP function menu.
2 TouchTEST TONE.
3 TouchSTART to start the test tone out-
put.
Thetest tone is outputted. It rotates from
speakerto speaker in the following sequence
atintervals of about two seconds.The current
settingsfor the speaker over which youhear
thetest tone are shown in the display.
FRONT-L(front speaker left)—CENTER (center
speaker)—FRONT-R(front speaker right)—
REAR-R(rear speaker right)—REAR-L (rear
speakerleft)—SUB WOOFER (subwoofer)
Checkeach speaker output level. If no adjust-
mentsare needed, per form step 5 to stop the
testtone.
#Thesettings do not appear for speakers
whosesize is set OFF.
Available accessories
En
64
Section
04