Before You Start

Removing the front panel

%Push the release button downward and release the front panel.

Take care not to grip it too tightly or to drop the front panel and protect it from contact with water or other fluids to prevent perma- nent damage.

Attaching the front panel

%Replace the front panel by holding it upright to the unit and clipping it securely into the mounting hook.

Release button

Resetting the microprocessor

Pressing RESET lets you reset the micropro- cessor to its initial settings.

The microprocessor must be reset under the following conditions:

!Prior to using this unit for the first time after installation

!If the unit fails to operate properly

!When strange or incorrect messages ap- pear on the display

1 Turn the ignition switch OFF.

Section

02

2 Press RESET with a pen tip or other

pointed instrument.Before YouStart

RESET button

Note

After completing connections or when you want to erase all memorized settings or return the unit to its initial (factory) settings, switch your engine ON or set the ignition switch to ACC ON before pressing RESET.

Use and care of the remote control

Installing the battery

Slide the tray out on the back of the remote control and insert the battery with the plus (+) and minus (–) poles pointing in the proper di- rection.

!When using for the first time, pull out the film protruding from the tray.

WARNING

Keep the battery out of the reach of children. Should the battery be swallowed, immediately consult a doctor.

En

9

Page 9
Image 9
Pioneer AVH-P4950DVD Resetting the microprocessor, Use and care of the remote control, Removing the front panel