Using other functions
Reducing the level of an analog signal
The input attenuator lowers the input level of an analog signal when it’s too strong. You can use this if you find the that the OVER indicator is lights often, or you can
hear distortion in the sound.1
SLEEP | VIDEO | ANALOG |
| SEL | ATT |
SR+ | DIMMER |
|
D.ACCESSCLASS
•Press ANALOG ATT to switch the input attenuator on or off.
10
Dimming the display
You can choose between four brightness levels for the front panel display. Note that when selecting sources, the display automatically brightens for a few seconds.
SLEEP | VIDEO | ANALOG |
| SEL | ATT |
SR+ | DIMMER |
|
D.ACCESSCLASS
•Press DIMMER repeatedly to change the brightness of the front panel display.
Watching video and audio sources independently
You can listen to a sound source and select a different video source on your TV.
SLEEP | VIDEO | ANALOG |
| SEL | ATT |
Switching the speaker impedance
We recommend using speakers of 8Ω with this system, but it is possible to switch the impedance setting if you plan to use speakers with a 6Ω impedance rating. Use the front panel controls to do this.
• With the receiver in standby, press STANDBY/ ON while holding down the SPEAKERS button.
SR+DIMMER
D.ACCESSCLASS
•While listening to a source, press VIDEO SEL (VIDEO SELECT) to select the video source you want to watch. Press repeatedly to cycle through the possible video sources. You can select DVD, TV, SAT, DVR1, DVR2, VIDEO1, VIDEO2 or OFF (no video signal).2
Using the sleep timer
The sleep timer switches the receiver into standby after a specified amount of time so you can fall asleep without worrying about the receiver being left on all night. Use the remote control to set the sleep timer.
SLEEP | VIDEO | ANALOG |
| SEL | ATT |
SR+ | DIMMER |
|
Each time you do this, you switch between the impedance settings:
•SP 6 OHM – Use this setting if your speakers are rated at 6Ω.
•SP 8 OHM – Use this setting if your speakers are rated at 8Ω or more.
Checking your system settings
Use the status display screen to check your current settings for features such as surround back channel processing and your current MCACC preset.
AUDIO | SUBTITLE | HDD | DVD |
DISP |
| CH | CH |
STATUS | SIGNAL SEL | SBch | STEREO |
MULTI OPE | THX | STANDARD | ADV. SURR |
SHIFT | PHASE | MCACC | S.DIRECT |
|
D.ACCESSCLASS
•Press SLEEP repeatedly to set the sleep time.
| 30 min |
| 60 min | ||
|
| ||||
|
| Off |
|
| 90 min |
|
|
|
| ||
•You can check the remaining sleep time at any time by pressing SLEEP once. Pressing repeatedly will cycle through the sleep options again.3
1Press STATUS to check the system settings. These appear on both the OSD and the front panel display.4
STATUS
96kHz | STEREO |
| |
Signal |
| Select | : AUTO |
SBch | Processin | : OFF | |
Video | Select | : OFF | |
MCACC | Position | : M1 | |
Room2/REC SEL | : SOURCE | ||
Room3 |
| : SOURCE | |
Note
1.The attenuator isn’t available with digital sources, or when using the Stream Direct modes.
2.Note that this feature will not work with video sources assigned to either of the HDMI video inputs.
3.You can also switch off the sleep timer simply by switching off the receiver.
4.If the Pure Direct mode is switched on, some settings above will show OFF, even though they are on.
65
En
