Additional information | 12 |
Symptom | Remedy |
No picture. | • If your display device is not SD (480i/576i) compatible then neither the setup screens or the 480i/576i to |
| HDMI converted video will be displayed. In this case, connect using the component, |
| video jacks. |
| • Depending in the output settings of the source component, it may be outputting a video format that can’t |
| be displayed. Change the output settings of the source, or connect using the component, |
| composite jacks. |
No sound, or sound suddenly ceases.
•Check that the HDMI AV setting is set to AMP/THROUGH.
•If the component is a DVI device, use a separate connection for the audio.
•If analog video is being output over HDMI then there will be no HDMI audio output. Please use a separate connection for the audio.
•Check the audio output settings of the source component.
Noisy or distorted picture. | • Sometimes a video deck may output a noisy video signal (during scanning, for example), or the video |
| quality may just be poor (with some video game units, for example). The picture quality may also depend on |
| the settings, etc. of your display device. Switch off the video converter and reconnect the source and display |
| device using the same type of connection (component, |
| • If the problem still persists when connecting your HDMI component directly to your monitor, please |
| consult the component or monitor manual or contact the manufacturer for support. |
|
|
iPod messages
Symptom | Cause | Action |
Error I1 | There is a problem with the signal path from the | Switch off the receiver and reconnect the iPod to the receiver. |
| iPod to the receiver. | If this doesn’t seem to work, try resetting your iPod. |
|
|
|
Error I2 | The software version being used with the iPod | Update the software being used with the iPod (software |
| needs to be updated. | versions prior to iPod update |
|
|
|
No Track | There are no playable songs currently stored in | Input some music files compatible with iPod playback. |
| the iPod. |
|
|
|
|
Note
•If the unit does not operate normally due to external effects such as static electricity disconnect the power plug from the outlet and insert again to return to normal operating conditions.
79
En
