Polaroid 111523 manual Control Panel

Repair Manual Macro 5 SLR Camera

Control Panel

Caution: Shock Hazard - High Voltage

Note: Use a dump stick to fully discharge the strobe capacitors before attempting to remove or replace the control panel.

1.Removal (Figure 5-9)

a.Remove the left/right cover assembly as explained on page 39.

b.Remove the rear cover assembly as explained on page 45.

c.Remove the bottom cover as explained on page 47.

d.Disconnect the white ribbon cable from the logic PC board.

e.Gently pull out the control panel. (This disconnects the control panel from male connector J27 on the logic PC board).

f.Disconnect electrical cable J11 (X-Sync IN/OUT) from the logic PC board.

Note: Be careful not to break the two black wires soldered to the X-Sync receptacle on the control panel.

White Ribbon

Cable

Control

Panel Logic PC

Board

J11 Electrical

Cable

Figure 5-9 Control Panel

55