Repair Manual | Macro 5 SLR Camera |
|
|
c.Connect the following electrical cables from the logic PC board:
•J15 (Piezo)
•J16 (Date Code Module)
•J23 (Film Door Switch)
•J25 (Camera Back Flex)
Note: If it was necessary to remove the strobe and logic PC boards and control panel during the removal of the camera back, make sure that these components are properly reassembled. For reassembly, refer to the appropriate assembly procedures in this section of the manual.
d.Install the bottom cover as explained on page 48.
e.Install the rear cover assembly as explained on page 46.
f.Install the left/right cover assembly as explained on page 42.
61
