Repair Manual | Macro 5 SLR Camera |
|
|
Cone
Assembly
Support
Plate
Camera Back
Figure 5-11 Camera Back
2.Reassembly
a.Place cone/turret assembly onto the camera back. Notes: Make sure the:
•Cone alignment holes are properly located over the camera back pins.
•Plastic support plate is properly positioned on the on the gear side of the camera back; for proper screw hole alignment.
•Strobe and logic PC boards, and control panel are properly positioned on the camera back.
b.Using a torx driver, install and tighten the six (6) screws that secure the camera back to the cone assembly.
60
