Repair Manual | Macro 5 SLR Camera |
|
|
Trigger PC Boards
Caution: Shock Hazard - High Voltage
Note: Use a dump stick to fully discharge the strobe capacitors before attempting to remove or replace the trigger PC board.
1.Removal (Figure 5-7)
a.Remove the left/right cover assembly as explained on page 39.
b.Remove the front cover assembly as explained on page 43.
c.Disconnect electrical cable J32 from the applicable trigger PC board.
d.Using a soldering iron and a solder sucker, unsolder the white trigger wire from the trigger coil.
Note: Be careful not to damage the trigger coil.
e.Using a torx driver, remove the two (2) screws securing the trigger PC board to the front cover support mounts.
f.Lift out the trigger PC board.
51
