Repair Manual | Macro 5 SLR Camera |
|
|
Logic PC Board
Caution: Shock Hazard - High Voltage
Notes: • Use a dump stick to fully discharge the strobe capacitors before attempting to remove or replace the control panel.
•The logic PC board firmware (CPU chip) can easily be damaged by static discharges. Always use an
1.Removal (Figure 5-10)
a.Remove the left/right cover assembly as explained on page 39.
b.Remove the rear cover assembly as explained on page 45.
c.Remove the bottom cover as explained on page 47.
d.Remove the control panel as explained on page 55.
e.Disconnect the following electrical cables from the logic PC board:
•J13 (Shutter Solenoid)
•J14 (Aim Lights)
•J15 (Piezo)
•J17 (Strobe Control)
•J18 (Strobe Data)
•J21 (VBat - Film Pack Battery)
•J23 (Film Door Switch)
•J24 (Encoder PC Board)
•J25 (Camera Back Flex)
f.Gently slide out the logic PC board.
57
