UPS SETUP
3.Remove the front cover from the bottom cabinet to access the front shipping bracket.
Press and release the handle latch at the bottom of the cover and then lift the cover up and off the cabinet.
4.Remove the three M10 bolts securing the rear shipping pad to the pallet and remove the shipping pad (see Figure 3).
NOTE Hold the back of the cabinet so that the bolts can be removed easily without the cabinet rolling backward.
5.Remove the two M10 bolts securing the front shipping bracket and remove the bracket.
If needed, adjust the leveling feet to release the bracket.
Front Shipping
Bracket
M10 Bolts
Stabilizing Bracket
M10 Bolts
M4 Screws
Shipping Pad
Figure 3. Removing the Brackets and Shipping Pad
6.Reinstall the front cover removed in Step 3.
Hang the top edge of the cover on the cabinet first, then lower the bottom edge and snap into place.
10 | EATON Powerware® 9155 Parallel UPS |