Installation Setup

4.If an optional caster cart is included for cabinet mobility, see •Caster Cart Installation" on page 10 for information about mounting the cabinet on the cart and stabilizing it using the cart foot pads.

5.After placing the cabinet in its intended operating location, cut the lifting straps or slip them off the cabinet base tabs.

6.If you are installing an external battery cabinet, continue to •Battery Cabinet Installation" on page 17.

If you do not have an external battery cabinet, continue to •UPS Startup" on page 49 for plug-receptacle units or to •Electrical Installation" on page 23 for hardwired units.

Nine- and Twelve-Slot Cabinets

NOTE The 12-slot Powerware 9170 UPS cabinet with non-isolated output is shipped with two stabilizer brackets. These brackets must be attached to the wall or the floor behind the UPS cabinet (see page 11).

1.Open the top of the carton by cutting the straps that hold the cover to the carton. Lift the cover off.

2.Remove the pallet ramp packed on top of the cabinet. Locate the ramp-mounting hardware (supplied in the accessory kit) and attach the ramp to the pallet as shown in LTS-1724, accompanying the hardware.

3.Remove any packing material inside the carton. Also remove cartons containing front panel bezels, electrical or mechanical hardware, and printed material.

4.Lower the four cabinet casters (one at each corner of the cabinet base) by using a 1/2￿ hex-style socket wrench to turn each bolt clockwise.

5.With all casters fully extended, carefully roll the cabinet down the ramp and to its intended operating location.

6.To stabilize the cabinet in its operating location, turn the four caster bolts counter-clockwise until the cabinet rests on the floor. Place a plastic cap into each bolt access hole.

Powerware® 9170 User's Guide ￿ LTM-1344 B Uncontrolled Copy

9