Precor C932 owner manual Diagram 7 Install the display console

C O M M E R C I A L P R O D U C T S D I V I S I O N

a.Place a washer (D) onto each of two ¾-inch screws (C).Thread the screws through the front panel and into the upright support. See Diagram 6, #2. Do not fully tighten the screws. Leave room for final adjustments.

CAUTION: Avoid pinching the cable with the bolts and spacers.

b.Place a washer (D) and barrel spacer (B) on each of two 2-inch screws

(A). Insert the screws through the upright support and thread them into the base mounts. See Diagram 6, #3. Do not securely tighten the screws until after the unit has been fully assembled.

8.Attach the left side upright support to the base assembly. Diagram 6. Align the upright support with the base assembly mounting bracket and secure it by following steps 7a. and 7b.

Diagram 7 Install the display console.

Display console

Display console mounting brackets

Upright support

9.Position the display console onto the upright supports. Diagram 7. Make sure that the cable is routed through the top of the upright support. Have an assistant hold onto the cable (see inset) and then, rest the display console on the upright supports and align the mounting holes.

CAUTION: Do not crimp or pinch the cable! Crimped or pinched cables are not covered by the Precor limited warranty.

page 13