C O M M E R C I A L | P R O D U C T S | D I V I S I O N |
Diagram 11 Secure the upper handrail clamp. |
| |
Handrail clamp |
|
|
Washer (F) with |
|
|
|
| |
Tighten the screws, |
|
|
but leave room for |
|
|
adjustments. |
|
|
12.Install fasteners in the handrail clamp. Diagram 11. Return to the center handrail clamp and place a large washer (F) onto each of two screws (E). Thread the screws through the handrail clamp. Finger tighten.
CAUTION: Do not overtighten the screws or you may inadvertently cause stress cracks.
Diagram 12 Secure the fasteners. | 2 | |
Second: Alternately | ||
| ||
tighten four side |
| |
upright screws. |
| |
First: Alternately |
| |
tighten four front | 3 | |
panel screws. | ||
Third: Alternately |
| |
tighten the four |
| |
screws that secure | 1 | |
the console to the | ||
uprights. |
|
13.Tighten all mounting screws with the hex key (H) provided. Diagram 12. Start at the front of the treadmill with the four screws that attach the upright supports to the front panel. Tightening these screws first helps pull the rest of the treadmill’s parts into alignment.Then, proceed with tightening the four screws (A) that secure the upright supports and the four display console assembly screws (C).
Important: For proper alignment, it is critical that the fasteners are tightened in the order shown in Diagrams 12 and 13.
page 16
