C O M M E R C I A L P R O D U C T S D I V I S I O N
11.Install the center handrail. Loosen the four fasteners in the handrail clamp bracket with the hex key provided. See Diagram 9, #1.The center handrail is packaged in two pieces. Install one side at a time by following these steps:
a.Insert a handrail end cap. See Diagram 9, #2.
b.Slide the end of the handrail into the center clamp and rotate the handrail so that it falls inside the end cap. See Diagram 9, #3.
Diagram 10 Secure the display | 2 |
console and center | |
handrail. |
|
Center handrail |
|
mounting bracket |
|
(right side) | 1 |
| |
with washers (D) |
|
(right side) |
|
Handrail end cap |
|
screw (C) with |
|
washer (F) |
|
(left side) |
|
3 | 4 |
c.Align the center handrail’s mounting bracket with the holes in the upright support. See Diagram 10, #1. Insert two
(D) and finger tighten. See Diagram 10, #2. Do not securely tighten the screws until both sides of the center handrail have been attached. See Diagram 10, #1 and #2.
d.Align the mounting holes in the handrail with the end cap. Place a washer (F) on screw (C) and insert the screw. Finger tighten. See Diagram 10, #4.
e.Follow steps 9a. through 9d. on the opposite side.
page 15
