Precor M9.20s owner manual Stop

INCLINE	Use the INCLINE	keys to change the running bed incline up to 10 %.
	Simply, press the appropriate arrow key until the desired percent of incline is
	displayed. You can change the incline anytime during a workout.
	When you change incline, note that the number shown on the display changes
	faster than the elevation motor can respond. Once you select an incline, there
	is a brief delay before the running belt reaches that elevation.
	Important: Whenever you change the incline, always use one hand to hold
	onto the handrail.
STOP	To pause during your workout or to end your workout, press the STOP key.
	The running belt gradually slows to a stop and the displays on the console
	show your workout statistics.
HOLD TO RESET	To return to the start-up prompt, press and hold the HOLD TO RESET key for a
	few seconds. Your workout statistics are added to the cumulative totals.
SCAN/ENTER	The SCAN/ENTER key has two functions which let you:
	• alternate between the displays every few seconds (SCAN)
	• select the specific workout information you want to display (ENTER)
	• address each prompt and “enter” the information into the treadmill’s
	memory (ENTER).
	SCAN
	In general, the electronic console display is set to scan, so the different
	features (DISTANCE, TIME, SPEED, CALORIES, and INCLINE) alternately
	appear in sequence every few seconds. A pair of lights next to the word
	“SCAN” indicates that you are in SCAN mode. Another pair of lights on the
	display indicate which feature is currently displayed.
	ENTER
	To cause a specific feature, such as the SPEED, to continuously appear on the
	display, press the ENTER key until the two round indicator lights appear next to
	the word SPEED.
	To specify a weight, select a workout mode, or reset U.S. Standard or Metric
	configurations, you need to use the ENTER key.
ACTIVATE	If the magnetic safety key is not in the ACTIVATE position, you cannot turn
	ON the treadmill. If used properly, the magnetic safety key helps to protect you
	from injury during your workout. Attach the magnetic safety key to your clothing
	prior to stepping onto the running belt and beginning your workout. If you
	encounter a problem during your workout, simply pull on the safety key’s cord
	to stop the running belt. When the magnetic safety key is removed from the
	ACTIVATE position, it trips the treadmill’s circuit breaker, turns OFF the tread-
	mill and gradually slows the running belt to a stop.
OFF	After completing your workout by pressing the STOP key, move the magnetic
	safety key to the OFF position. This turns OFF the treadmill. To prevent
	unauthorized use, remove the magnetic safety key and store it in a safe place.

page 20