189
Using the Command Line Interface
Figure A-4 Result of “set ?” CLI command
Example 3b. Display parameters based on letter sequence
This example shows entries for parameters that start with the letter “i”. The more letters you enter, the fewer the results
returned. Notice that there is no space between the letters and the question mark.
[Device Name]> show ipa?<CR>
Figure A-5 Result of “show ipa?” CLI command
[Device Name]> show iparp?<CR>
Figure A-6 Result of “show iparp?” CLI command
Example 4. Display Prompts for Successive Parameters
Enter the command, a space, and then "?". Then, when the parameter prompt appears, enter the parameter value.
Result: The parameter is changed and a new CLI line is echoed with the new value (in the first part of the following
example, the value is the IP Address of the TFTP server).