Proxim AP-2500 Set and Change Passwords

38
Installation & Basic Configuration
5. Select the Key that the Access Point will use to encrypt outgoing data from the Encrypt Data Transmissions
Using drop-down menu. By default, this parameter is set to Key 1.
6. Repeat these steps for the second slot (if applicable).
7. Click OK.
8. Reboot the AP for these changes to take effect.
Figure 2-21 WEP Encryption
Set and Change Passwords
1. Click Configure > Management > Passwords.
2. Set the SNMP Read Password. Enter a password in both the Password field and the Confirm field.
• An SNMP management program must be configured with this same password (also known as a community
string) to gain read access to the AP. The default password is “public”.
3. Set the SNMP Read/Write Password. Enter a password in both the Password field and the Confirm field.
• An SNMP management program must be configured with this same password (also known as a community
string) to gain read and write access to the AP. The default password is “public”.
4. Set the Telnet (CLI) Password. Enter a password in both the Password field and the Confirm field.
• This is the password for the CLI interface (whether you access it via Telnet or the AP’s serial port). The default
password is “public”.
5. Set the HTTP (Web) Password. Enter a password in both the Password field and the Confirm field.
• This is the password for the HTTP Web browser interface. The default password is “public”.
6. Click OK.