2 – QCP2330/2332 Installation and Removal
Q
2.1.2
Jumpers
Jumpers J1 (QCP2332) and J2 on the QCP2330/2332 HBA determine the default state of connectors J5 (QCP2332) and J6, respectively. The jumpers are set at the factory with a jumper plug on pins
CAUTION! Changing the jumper settings can result in the HBA being inoperable.
2.2
Installation and Removal
The following sections describe how to install the QCP2330/2332 HBA (standard and hot swap installations) as well as how to remove the HBA.
Before you install the QCP2330/2332 HBA in your computer, you need the following:
■A screwdriver (usually a Phillips #1)
■An optical, multimode cable with an
2.2.1
Installation in the Computer (Standard)
Perform the following steps to install the QCP2330/2332 HBA in your system. These instructions are for a standard installation (the computer is shut down). See section 2.2.2 for hot swap instructions.
1.Shut down the system.
2.Choose any available cPCI slot. (Check the indicator lights next to (or above) the available slots. The top two lights are off; the bottom light is amber.)
3.Place the QCP2330/2332 HBA into the slot. Carefully press the HBA into the slot until it seats firmly (the switch clicks into a locked position when the HBA is seated).
4.Connect the appropriate cables from the devices to the J5 (QCP2332) and J6 connectors.
5.Power up all external FC devices, then power up the system and observe the monitor. The HBA will not appear as part of the system components unless the driver has been installed; in which case, the HBA and corresponding driver are listed.
6.Check the QCP2330/2332 HBA hot swap LED1; it should be off, indicating that the HBA is active. The bottom indicator light next to the slot should be green (in some systems, the lights are above the slots).
See section 6 for detailed instructions on how to install the software driver.
If you need FCode, see section 2.4 for instructions on how to install or update the FCode on the QCP2330/2332 HBA.
