4 – QSB2340/2342 Installation in the Computer
Q
4.1.1
LEDs
The QSB2340/2342 LED1 and LED2 (QSB2342) function as shown in table
Table 4-1. LED1 and LED2 (QCP2342) Activity
Green LED | Amber LED | Activity |
|
|
|
On | On | Power |
On | Off | Online |
Off | On | Signal acquired |
Off | Flashing | Loss of synchronization |
Flashing | Flashing | Firmware error |
|
|
|
4.1.2
Jumpers
Jumpers J7 (QSB2342) and J8 on the QSB2340/2342 HBA determine the default state of connectors J10 (QSB2342) and J9, respectively. The jumpers are set at the factory with a jumper plug on pins
CAUTION! Changing the jumper settings can result in the HBA being inoperable.
4.2
Installation in the Computer
Before you install the QSB2340/2342 HBA in your computer, you need the following:
■A screwdriver (usually a Phillips #1)
■An optical, multimode cable with an
Perform the following steps to install the QSB2340/2342 HBA in your system:
1.Shut down the computer.
2.Remove the computer cover and save the screws.
3.Choose any available SBus slot.
4.Remove the slot cover.
5.Place the QSB2340/2342 HBA into the slot. Carefully press the HBA into the slot until it seats firmly.
6.Connect the appropriate cable from the devices to the J1 and J2 connectors.
7.Carefully reinstall the computer cover. Insert and tighten the computer cover screws.
8.Power up all external FC devices, then power up the system and observe the monitor.
NOTE: SunSPARC systems do not display the BIOS banner.
