Q-Logic 2300 series Installing the Solaris Sparc Driver from a CD-ROM, Continue with in section

6 – Solaris SPARC Driver Installation

Installing the Solaris SPARC Driver from a CD-ROM

Q

qla2300 driver versions 4.11 (and earlier) have the following package names:

❑QLA2300-1 (Solaris 2.6)

❑QLA2300-2 (Solaris 2.7)

❑QLA2300-3 (Solaris 2.8 and 9)

Checks within the package installation will terminate the new driver installation if a pervious version of the driver package is found.

For additional information, please review the latest Solaris README.TXT file, available on the QLogic web site (www.qlogic.com).

6.3

Installing the Solaris SPARC Driver from a CD-ROM

Perform the following steps to install the Solaris SPARC driver from a CD-ROM to your system.

NOTE: To install the QLA2300 driver, you must have superuser privileges.

1.Log on to the system as superuser.

2.Create a temporary directory where you can copy the driver.

3.Change the directory (cd) to the CD-ROM mount point (usually /cdrom, but the location varies. Ask your system administrator for the specific directory).

4.Change the directory (cd) to the Solaris directory.

5.Copy (cp) the qla2300_pkg.Z file from the CD-ROM to the temporary directory created in step 2.

6.Change the directory (cd) to the temporary directory created in step 2.

7.At the command prompt, type:

uncompress ./qla2300_pkg.Z

8.Step 7 produces a file in the same directory called qla2300_pkg.

9.At the command prompt, type:

pkgadd -d ./qla2300_pkg

10. Continue with step 7 in section 6.4.

6.4

Installing the Solaris SPARC Driver from the QLogic Web Site

Perform the following steps to download the Solaris SPARC driver from the web to your hard disk, then install the driver on your system.

NOTE: To install the QLA2300 driver, you must have superuser privileges.

6-2 CF2351102-00 F