Q-Logic SANBOX2 manual ConnUnitPortControl

A

5 – Fibre Alliance MIB Objects

connUnitPortControl (1.3.6.1.3.94.1.10.1.16)

This object is used to control the addressed connUnit's port.

„resetConnUnitPort: If the addressed connUnit allows this operation to be performed to this port, the addressed port performs a vendor-specific ”reset” operation. Examples of these operations are: the Link Reset protocol, the Loop Initialization protocol, or a re-synchronization occurring between the transceiver in the addressed port to the transceiver that the port is connected to.

„bypassConnUnitPort: If the addressed connUnit allows this operation to be performed to this port, the addressed port performs a vendor-specific “bypass” operation. Examples of these operations are transitioning from online to offline, a request (non-participating) command to the Loop Port state machine, or removal of the port from an arbitrated loop by a hub.

„unbypassConnUnitPort: If the addressed connUnit allows this operation to be performed to this port, the addressed port performs a vendor-specific “unbypass” operation. Examples of these operations are the Link Failure protocol, a request (participating) command to the Loop Port state machine, or addition of the port to an arbitrated loop by a hub.

„offlineConnUnitPort: If the addressed connUnit allows this operation to be performed to this port, the addressed port performs a vendor-specific “offline” operation. Examples of these operations are disabling a port's transceiver, the Link Failure protocol, request (non-participating) command to the Loop Port state machine, or removal of the port from an arbitrated loop by a hub.

„onlineConnUnitPort: If the addressed connUnit allows this operation to be performed to this port, the addressed port performs a vendor-specific “online” operation. Examples of these operations are enabling a port's transceiver, the Link Failure protocol, request (participating) command to the Loop Port state machine, or addition of the port from an arbitrated loop by a hub.

„resetConnUnitPortCounters: If the addressed connUnit allows this operation to be performed to this port, the addressed port statistics table counters will be set to zero.

Each implementation may choose not to allow any or all of these values on a SET. On a read, if you do not support write, then return invalid. Otherwise, return the last control operation attempted.

Syntax

INTEGER {

unknown(1),

invalid(2),

resetConnUnitPort(3),

59047-03 B 5-43