A

4 – MIB-II Objects

egpNeighMode (1.3.6.1.2.1.8.5.1.14)

The polling mode of this EGP entity, either passive or active.

Syntax

INTEGER { active(1), passive(2) }

Access

read-only

Status

mandatory

egpNeighEventTrigger (1.3.6.1.2.1.8.5.1.15)

A control variable used to trigger operator-initiated Start and Stop events. When read, this variable always returns the most recent value that egpNeighEvent- Trigger was set to. If it has not been set since the last initialization of the network management subsystem on the Node, it returns a value of “stop”.

When set, this variable causes a Start or Stop event on the specified neighbor, as specified on pages 8-10 of RFC 904. Briefly, a Start event causes an Idle peer to begin neighbor acquisition and a non-Idle peer to re-initiate neighbor acquisition. A stop event causes a non-Idle peer to return to the Idle state until a Start event occurs, either by egpNeighEventTrigger or otherwise.

Syntax

INTEGER { start(1), stop(2) }

Access

read-write

Status

mandatory

egpAs (1.3.6.1.2.1.8.6)

The autonomous system number of this EGP entity.

Syntax

INTEGER

Access

read-only

Status

mandatory

59047-03 B

4-55

Page 73
Image 73
Q-Logic SANBOX2 manual EgpNeighMode, EgpNeighEventTrigger, EgpAs