Quadra-Fire CB1200I-B E. Adjustable Hearth Support, Size 9”d x 45”w, 2” to 10” Height Adjustment

CB1200-I Pellet Insert		R
E. Adjustable Hearth Support
Size: 9”d x 45”w, 2” to 10” Height Adjustment	ExPLODED VIEW OF SCISSORS
Included in Kit: (1) trim top, (1) trim front, (2) trim sides,
double-sided tape (already installed)	SCREWS ARE CIRCLED
Tools Needed: Phillips head screw driver, sheet metal
shears, measuring tape, gloves
1. The 10 screws on each set of scissors will already be	DOUBLE-SIDED TAPE	DOUBLE-SIDED TAPE
loose when shipped. Figure 20.1.	Figure 20.1

2.Expand scissors to desired height. Tighten screws to hold in place using Phillips head screw driver. Figure 20.2.

3.Measure front and side trims to required height to cover scissors and mark pieces for cutting. Cut excess mate-

rial from top of trim’s edge, not bottom. This edge will	ExPAND SCISSORS TO DESIRED HEIGH T
be sharp; wear gloves to prevent injury to your hands.
Figure 20.3.
4. Using sheet metal shears, cut trim along the marked
edge. The cut edge fits under lip of top trim, so it allows
for some variance in your straight edge.		CUT TOP EDGE OF TRIM,
5. The double-sided tape that holds front and side trims to	INSTALL FRONT TRIM LAST.	NOT BOTTOM EDGE
	CORNERS OVERLAP SIDE
scissors has a powerful bonding adhesive. Adjustments	TRIM PIECES
are extremely difficult once trim has adhered to tape. Do	Figure 20.2
a dry run first without removing paper from tape.

6.Place cut edge of trim under top lip and into position on scissors. Place side pieces on first and then front piece. The front piece overlaps side pieces.

7.Once you are satisfied with the positioning, remove trim

and set aside.

8. Remove the paper from double-sided tape that is to	Decorative tile
accept trim side. Align side and then press hard against
	may be installed
tape to secure side piece. Repeat for other side. Install
front trim piece last.
9. There are 3 holes in the back flange of the top to secure
it to the wall if necessary. Use the appropriate fastener
for the type of wall material, i.e., brick, sheetrock, etc.	Figure 20.3
NOTE: 3/8 inch (9.5mm) thick tile or like material can be
cut to size and fit under lip of top trim edge for a decora-
tive touch. Figure 20.3.

WARNING

Sheet metal trim edges will be sharp.

For safety purposes wear gloves.

Injury can occur.

Page 20 7014-083C October 26, 2006