Quadra-Fire CB1200I-B owner manual Appliance Set-Up, Rear Shroud Installation

	R	CB1200-I Pellet Insert
7	Appliance Set-Up

A.Rear Shroud Installation

1.Top Vent Installations

Parts Required:

Part 811-0680, Rear Shroud Kit.

Includes: Six galvanized steel shroud pieces, two cover plates and fastener package.

Part 811-0650, Rear Shroud Top Vent

Includes: Vent pipe and two 1/4 - 20 x 3/4" bolts with nuts.

Part 811-0660, 3" Top Vent Adapter or Part 811-0670, 4” Top Vent Adapter

2.Rear vent installations Parts Required:

Part 811-0680, Rear Shroud Kit. Part 811-0690, Rear Vent Kit

Includes: Rear Vent Adapter and fastener package.

					REAR SHROUD TOP
				VENT PART 811-0650
						Right Corner
Top Vent Opening
Left Corner
	Left			Corner
					Piece
	Filler
-Out				Rear
Knock	Access
Vent
Outside			Air			Vent
Pipe		Access

Tools Required:

Electric drill, 1/8" drill bit, Phillips screw driver, 3/8" wrench & 7/16" wrench, (7/16" socket wrench & high temperature silicone adhesive are also required for rear vent installations).

Figure 17.1

Complete the following procedures, based on your venting installation, prior to installing the rear shroud kit. (Note: All photos depict top vent installation).

Top Vent Installation Preparation

Filler Piece

Figure 17.2

Rear Shroud

Top Vent

Figure 17.3

1.Remove the top vent adapter from the vertical exhaust transition pipe. Figures 17.2 and 17.5.

2.Use 2 screws to attach left corner filler piece of rear shroud to the insert hopper. Figures 17.1 and 17.2.

3.Use (2) 1/4 - 20 x 3/4" bolts with nuts to install rear shroud top vent to the exhaust transition. See boxed area in Figure 17.3. (Circled area, top vent adapter, will be installed later).

4.Install the left shroud panel corner at 3 points, 2 screws into back of hopper and 1 down into the filler piece).

Figure 17.4

Left Corner

Piece

Figure 17.4

Vertical Exhaust

Transition Pipe

Top Vent Adapter

Figure 17.5

October 26, 2006 7014-083C Page 17