Quadra-Fire CB1200MI-MBK CB1200-I Pellet Insert Panel and Trim Set Cont’d, Completed View

R

CB1200-I Pellet Insert

F. Panel and Trim Set (Cont’d)

5.Hold side curtains in open position and lower panel set over insert setting lower edge of top panel in slot between hopper lid and panel support as shown in Figure 23.1. Place existing screw head (installed in Figure 23.2) into locator hole in floor of insert. Figure 23.2.

6.Lift hopper lid and press down on panel top while installing

(4) 8-32 x 3/8 inch screws into holes in panel support. (If screws have been factory installed, tighten to secure panel to panel support.) Return hopper lid to closed position.

7.Install a corner bracket on each side trim piece. Slide brackets into top trim from each side and secure with flathead screwdriver. Attach trim assembly to panel set as follows:

a. Ensure that brackets face towards the back.

b. Align trim assembly to panel set sides and slide down.

Figure 23.1

Panel Locator Hole

Figure 23.2

Figure 23.3

View of "L" Bracket

installed

Figure 23.4

Figure 23.5- Completed View

February 3, 2010 7014-188B Page 23