R
G. Optional Brick Set Installation
1.Slide bottom of left rear brick in first; rotate top edge to- ward rear of appliance and then rotate outer edge toward rear of appliance, until brick slides into place. Figure 24.1. Repeat for right rear brick.
2.Place left side brick along left side of firebox, making sure chamfered (beveled) back edge fits snugly next to left rear brick. Figure 24.2. Repeat with right side brick.
3.Complete brick set, correctly installed. Figure 24.4.
1
Figure 24.1
WARNING
Risk of Injury.
•Brick may have small wires protruding from the back of brick.
H.Brick Clip Installation
1.After the brick set has been installed, 2 brick clips need to be installed on the outer edge of baffle to keep the brick set in place. Remove the baffles from the appliance before installing the brick clips.
2.Using pliers, bend the brick clip slightly past 90° in the direction shown in Figure 24.4.
3.Position the brick clip as shown in Figure 24.4 and use pliers to crimp around the outside edge of the baffle. Figure 24.5 shows the finished shape of the brick clip after being bent around the outside edge of the baffle.
4.Slide the baffles back into place making sure that the brick clip holds the brick out toward the wall of the firebox. Push back on the sides so they keep the rear bricks in place. Repeat for the opposite side.
3 | 1 | 2 |
|
|
Figure 24.2
3 | 4 |
1 | 2 |
Figure 24.3
| Approximately | |
| 1 inch | |
| Outside edge | |
| of Baffle | |
Top outside | Brick Clip | |
corner of Baffle | ||
|
Figure 24.4
Installed Clip |
Figure 24.5
Page 24 | February 3, 2010 |
