Quadra-Fire CB1200MI-MBK, CB1200I Venting Systems, Full Reline With Outside Air Horizontal

	R	CB1200-I Pellet Insert
5	Venting Systems

A.Full Reline With Outside Air - Horizontal

CAUTION

Never draw outside combustion air from:

•Wall, floor or ceiling cavity

•Enclosed space such as an attic or garage

WARNING

Fire Risk.

Inspection of Chimney:

•Masonry chimney must be in good condition.

•Meets minimum standard of NFPA 211

•Factory-built chimney must be a minimum 6 inch (152mm) UL103 HT.

NOTE; Use metal plate around exhaust vent pipe and seal all edges with non-flammable insu- lation such as fiberglass, mineral wool or ceramic.

Do not use high temperature caulking materials to seal any edge to prevent furture service- ability.

Outside Air through Rear

Wall (Horizontal)

Figure 15.1

NOTE:

In Canada, where passage through a wall or partition of combustible construction is desired, the installation shall conform to CAN/CSA-B365.

NOTE:

•Illustrations reflect typical installations and are FOR DESIGN PURPOSES ONLY.

•Illustrations/diagrams are not drawn to scale.

•Actual installation may vary due to individual design preference.

February 3, 2010 7014-188B Page 15