R
I. Optional Log Set Placement Instructions
CAUTION
Logs are FRAGILE. Use extreme care when handling or cleaning logs.
1.Place the front log in first as shown in Figure 25.1 charred area surrounding firepot.
2.Set the left and right logs onto the front log, placing the holes in the base of the left and right logs over the locating pins in the front log. See Figure 25.2. Ensure that the charred ends are facing the firepot.
LOCATING PINS
Figure 25.1
Charred Areas in the Back
Top Log, Left | Top Log |
| Right |
| Front Log |
Figure 25.2
NOTE:
Due to the abrasive nature of a pellet appliance fire, the logs are not covered under warranty. Any placement vari- ation other than shown here can cause excessive heat and shall void the appliance warranty.
J. Thermostat Installation
1. A 12 volt AC thermostat is required to operate this pellet appliance. You may use the included wall mount thermo- stat or purchase an optional programmable thermostat or remote control. The included thermostat is equipped with an adjustable heat anticipator. The current rating is
.05 amps. The anticipator needs to be adjusted to the lowest setting available.
2.When mounting a thermostat on a wall, be sure to follow your thermostat installation instructions carefully.
NOTE: Thermostat must be mounted level for accu- rate readings. The thermostat should be mounted on an inside wall and not in direct line with the appliance convection air. Remove any packaging from inside the thermostat before using.
NOTE: If the thermostat is located too close to the appliance, you may need to set the temperature setting slightly higher to maintain the desired tem- perature in your home.
3.Open right side plane to access a 4 screw terminal block located on the bottom right hand side next to the power cord inlet. The center 2 screws are for the thermostat wires. The outer 2 are the mounting screws for the ter- minal block. Figure 25.3.
Caution
Shock hazard.
• Do NOT remove grounding prong from plug.
•Plug directly into properly grounded 3 prong receptacle.
•Route cord away from appliance.
•Do NOT route cord under or in front of appli- ance.
Terminal Block |
Center 2 Screws for |
Thermostat Wires |
Power Outlet |
Figure 25.3
February 3, 2010 | Page 25 |
