Quadra-Fire CUMBGAP-MBK, CUMPGAP-PMH C. Installing Chimney Components, Cumberland Gap Wood Stove

R

Cumberland Gap Wood Stove

Masonry Chimney Liner (Cont'd)

C. Installing Chimney Components

Chimney Connector

Wood Stud 2 in. (51mm) Clearance from chimney wall

Header

Fireclay liner 5/8 in. (16mm) Minimum or Equivalent.

Sill support

Fireclay liner 5/8 in. (16mm) Minimum or Equivalent.

Single wall connector or stove pipe.

This must be at least 24 gauge mild steel or 26 gauge blue steel. The sections must be attached to the appliance and to each other with the crimped (male) end pointing toward the stove. All joints, including the connection at the flue collar, should be secured with 3 sheet metal screws. Make sure to follow the minimum clearances to combustibles. Where passage through the wall, or partition of combustible construction is desired in Canada, the installation shall conform to CAN/CSA-B365.

Factory-built listed chimney connector (vented).

A listed connector (vented) must be used when installing this unit in a mobile home. The listed connectors must conform to each other to ensure a proper fit and seal.

Crimped	Flue Gas
End
	Direction
Toward
Stove

Thimble Assembly: 12 in. (305mm) of brick separation between clay liner and combustibles.

Figure 21.1

Secure pipe sections with a

minimum of 3 screws

Figure 21.2 Chimney Connector (Stove Pipe)

WARNING

Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Refer to the owner’s information manual provided with this appli- ance. For assistance or additional information consult a qualified installer, service agency or your dealer.

ADDITIONAL REQUIRED PARTS FOR REAR INSTALLATION:

•Baffle Diverter: Shipped with appliance located inside firebox

•Horizontal Flue Heat Shield, Part HTSHLD-7006: Not sup- plied, must be purchased from your local authorized dealer

NOTE: Optional Fire Screen, Part SCR-7006, can only be used in FULL Vertical installations.

WARNING

Fire Risk.

Follow Chimney Connector Manufacturer’s

Instructions for Proper Installation.

ONLY use connector:

•Within the room, between appliance and ceiling or wall. Connector shall NOT pass through:

•Attic or roof space

•Closet or similar concealed space

•Floor or ceiling

Maintain minimum clearances to combustibles

November 5, 2010 7006-188G Page 21