Quadra-Fire CUMPGAP-PMH D. Baffle Diverter, Required On All Horizontal Installations, Fire Risk

R

Cumberland Gap Wood Stove

D. Baffle Diverter

REQUIRED ON ALL HORIZONTAL INSTALLATIONS

Baffle Diverter:

•Packed inside the firebox

•Shipped flat from the factory.

•Use the template on page 15 to bend the baffle diverter into the proper position.

WARNING

Fire Risk.

Required on all rear horizontal installations.

Excessive smoke or flame spillage into the room may occur.

Figure 14.1

Slanted corner

Straight end to the back

1.Open both doors.

2.Hold the diverter in a vertical position with the straight edge going in first and then rotate it to the inside of the firebox as you slide the bent diverter over the ceramic blanket . Figure 14.1.

3.Place in position as shown in Figure 14.2 below. The front edge of the diverter will rest on the front edge of the manifold chamber in a flush position. The back edge will butt up against the back slanted corner.

4.Repeat for other side.

Ceramic Blanket

Manifold chamber

Cut end to the front

Figure 14.2

Page 14 7006-188G November 5, 2010