Quadra-Fire CUMPGAP-PMH Listing and Code Approvals, A. Appliance Certification, Model, Laboratory

R

Cumberland Gap Wood Stove

1 Listing and Code Approvals

A. Appliance Certification

Model:	Cumberland Gap
Laboratory:	OMNI Test Laboratories, Inc.
Report No & Date:	061-S-55-2
Type:	Listed Room Heater, Solid Fuel Type
Standard:	UL1482, UL737, ULC S627-00
	and (UM) 84-HUD, Mobile Home
	Approved.

NOTE: This installation must conform with local codes. In the absence of local codes you must comply with the UL1482, UL737, (UM) 84-HUD and NPFA211 in the U.S.A. and the ULC S627-00 and CAN/CSA-B365 Installation Codes in Canada.

D. BTU & Efficiency Specifications

EPA Certified:	3.44 grams per hour
Efficiency:	79.3%
BTU Output:	11,200 to 44,300
Heating Capacity:	1,940 to 3,350 sq ft
	depending on climate zone
Vent Size:	6 inches
Firebox Size:	2.39 cubic feet
Max Wood Length:	20 inches
Fuel:	Cord Wood
Shipping Weight:	462 lbs

The Quadra-Fire Yosemite Wood Stove meets the U.S. Environmental Protection Agency’s 1990 particulate emis- sion standards.

B. Mobile Home Approved

•This appliance is approved for mobile home installa- tions when not installed in a sleeping room and when an outside combustion air inlet is provided.

•The structural integrity of the mobile home floor, ceil- ing, and walls must be maintained.

•The appliance must be properly grounded to the frame of the mobile home with #8 copper ground wire, and use only listed double-wall connector pipe.

•Outside Air Kit, part 831-1780 must be installed in a mobile home installation.

C. Glass Specifications

This stove is equipped with 5mm ceramic glass. Replace glass only with 5mm ceramic glass. Please contact your dealer for replacement glass.

Quadra-Fire is a registered trademark of Hearth & Home Technologies.

WARNING

Fire Risk.

Hearth & Home Technologies disclaims any responsibility for, and the warranty will be voided by, the following actions:

•Installation and use of any damaged appliance.

•Modification of the appliance.

•Installation other than as instructed by Hearth & Home Technologies.

•Installation and/or use of any component part not approved by Hearth & Home Technologies.

•Operating appliance without fully assembling all components.

•Operating appliance without legs attached (if supplied with unit).

•Do NOT Overfire - If appliance or chimney connector glows, you are overfiring.

Any such action that may cause a fire hazard.

Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage.

For assistance or additional information, consult a qualified installer, service agency or your dealer.

NOTE: Hearth & Home Technologies, manufacturer of this appliance, reserves the right to alter its products, their specifications and/or price without notice.

Page 4 7006-188G November 5, 2010