Quadra-Fire CUMPGAP-PMH Appliance Set-Up, A. Door Handle Assemblies, Cumberland Gap Wood Stove

R

Cumberland Gap Wood Stove
	7	Appliance Set-Up
A. Door Handle Assemblies
	All Doors
	• Install washer on door handle shaft.
	• Slide door handle through door.
	Right Front & Side Doors:
	• Install additional spacing washer(s) as needed.
	• Install bushing, door latch and locknut.
	Caution! Do not overtighten locknut. Door handle
	needs to move smoothly.
	Left Front Door:
	• Install locking pin and locknut. Securely tighten locknut.
	This handle assembly is stationary.
	All Doors
			Figure 24.3 - Side Door
	• Insert fiber door handle with threads going into door
	handle shaft. Turn handle clockwise until tight.

	Left Handle
	Assembly is
	Stationary
	Lock Nut
	Locking Pin
	Washer
Fiber	Door
	Handle
Handle
	Shaft

Figure 24.1 - Left Front Door

Spacing Washers

Door
Latch	Bushing
Lock
Nut	Washer	Handle	Fiber Handle

B.Adjusting The Blower Speed Control

*If Necessary

*The blower speed control for this unit is adjusted at the factory, and normally does not require further adjustment.

NOTE: When the speed control is turned clockwise, it will click on to high speed. Turn the speed control clockwise to decrease the speed. At full clockwise, the blower should blow gently, but should not stop.

1.With the stove plugged in, turn the speed control knob to slow (full clockwise).

2.With a small screwdriver, adjust the blower speed by turning the adjustment mechanism through the hole on the side of the speed control.

3.Adjust the speed so the blower runs slowly, but does not stop. Turn clockwise to slow the blower and counterclockwise to increase the speed.

Figure 24.2 - Right Front Door

Page 24 7006-188G November 5, 2010