Tiltable Plasma Display Wall-Mount Hardware: PDK-5006

4) Adjusting the angle

This mounting can be tilted 25 degrees, without set increments.

The work should be done by two people.

1Loosen screw c on the left and right vertical frames.

2While sliding the arm down, push the display to the desired angle.

3Once the desired angle is reached, tighten screw c on the left and right frames.

a

c

 

When mounting the display flush or parallel to the wall,

 

secure the movable and fixed portions of the mount frame

 

by tightening the screws a, as shown. This prevents

 

accidental tilting of the display. You must also tighten the

 

left and right c screws.

Wire, flat bar

X

 

After mounting the unit at an angle, an additional reinforcement measure can be taken by attaching an appropriate wire and a flat bar using screws a.

When the angle is set to less than 5°, please secure using wires or a flat bar etc.

Measuring the opening distance X enables approximate angle values to be determined.

X

Angle

 

 

181 mm

 

 

236 mm

10°

 

 

290 mm

15°

 

 

341 mm

20°

70

Page 70
Image 70
Pioneer 502MX Adjusting the angle, By tightening the screws a, as shown. This prevents, Left and right c screws