Plasma Display Ceiling Suspension Hardware (one-side type): PDK-5002

3) Mounting the plasma display

1Remove the hole rivets (six, in a vertical line), from the rear of the plasma display.

2Mount the supplied monitor mount bolt assembly (three per side) to the mount opening at the rear of the display.

3Loosen the upper mount screws securing the left and right monitor brackets, and tilt the brackets to full extension. (Do NOT loosen the lower screws.)

4Lift the plasma display, and insert the monitor mount bolt assemblies into the monitor brackets.

5To avoid twisting and deforming the plasma display, always tighten the nut for the monitor mount bolt assembly

(three per side) after loosening the upper mount screws of the monitor brackets.

6Adjust the tilt of the plasma display (tiltable 25 degrees from horizontal).

Determine the desired angle, then re-tighten the upper mount screws for both the left and the right monitor brackets. Holes in the monitor brackets serve as angle marks (in 5-degree increments).

7Adjust the left and right rotational angle of the plasma display (panning over a range of 45° on each side).

Hold the monitor frame and rotate the display to the desired angle, then secure the display assembly by tightening

the vibration-preventing hexagonal socket head bolts (M6 × 30).

8Connect cables to the display by running them through cable opening in the post COMP. If the cables are too thick to pass through the cable openings in the post COMP, connect them to the display directly, or replace with thinner cables.

 

Connection cable

Hexagonal socket head bolt

Post COMP

 

(vibration preventive) (M6 x 30)

[SME60H300FZK]

7

6

4

To connector on the main unit

Holes serving as angle marks

3

1 Hole rivet

2 Monitor mount bolt assembly

59

Page 59
Image 59
Pioneer 502MX technical manual Mounting the plasma display