Speaker System

4.9.3 Mounting to the main unit

1)Installing procedure

Install the speaker according to the procedure (1) through (3) below:The illustrations below show the speaker (for right) to be mounted to the right of the display.

Caution:

When the speaker is mounted to the display, the op- eration panel of the display cannot be used. A remote controller supplied to the display should be used.

(1) Affixing the mounting plate to the speaker

Set the mounting plate to 0.5 to 1cm be- low the top of the speaker.

 

Mounting plate

UP

Seal (2 places)

1.Make sure of right and left speakers by confirming the indication of "Right" and "Left" on the rear side. Set the mount- ing plate to the corresponding speaker so as to get a proper combination of speaker and mounting plate.

2.Peel off two seals at the affixing plane on the mounting plate.

3.Make sure of the position to be affixed and affix the mounting plate to the side of the speaker.

Note : Mounting plates should be attached to speakers only when speakers are attached to the display.

(2) Installing the metal fixture on the speaker

Washers M8 (φ 25) are supplied for third-party metal fixtures.

Mount commercial fixtures by the two-point mounting method to the mounting holes provided at the center or bottom of the back of the speaker. These mounting holes are at different levels. To make the hole levels

even, use additional washers until they are flush.

(3)Installing the speaker to the side of the plasma display

Plasma display

UP

Hole rivet

Hexagon socket screws

1.Remove the hole rivets (two places on a single side) from the rear of the display (by turning the hole rivet with a coin and so forth).

2.Make sure of right and left position by looking at the indication of "Right" and "Left" on the rear side of the speakers. With the "UP»" indication placed upward, install the upper metal fixture first and then the lower one on the display.

(To make allowance for clearance correction, tempo- rarily install the display.)

3.Adjust the position of the display so that the clearance between the speakers and the display is even, then fully tighten the screws.

When you install the speakers, using screws other than those provided may cause the speakers to fall or malfunction.

Mounting metal fixture (for upper side)

UP

Countersunk screw

Mounting plate

1.Since the upper metal fix- tures are distinguished be- tween right and left ones, make sure of speakers and right and left metal fixtures properly before setting up.

2.Install the metal fixtures at the position as shown in the figure to the left.

Caution Use only the screws provided for installation.

When the display is to be moved after installing the speakers, do not hold the speaker itself. Please move the display

by holding its lower side.

76

Metal fixture (for lower side)

Page 76
Image 76
Pioneer 502MX technical manual Speaker System, Installing procedure, Affixing the mounting plate to the speaker