Integrator Mode
15) Initializing Adjustments (ALL DEFAULT)
You can restore items adjusted in the integrator mode to their
You can reset all of the PICTURE, WHITE BALANCE and SCREEN adjustment values (refer to 5.4.3 1), 2) and 3)) to their factory preset values in one go.
1Before entering integrator mode, switch the unit to the input (INPUTs 1 to 4) with the parameters which you want to return to their original settings (refer to section 5.4.1, “About the integrator mode”).
For initialization, use input signals that would be used in an actual production run.
Make sure that the current color mode is set to the mode in which you want to restore parameters to factory presets (refer to section 5.4.3, 5)).
The ID number of the unit of items will be indicated in the upper right corner of the screen, where “–
Select DEFAULT.
2Move the cursor to “YES” using the 2button on the remote control or the operating panel of the main unit, and press the SET button. This restores the following parameters to their
•PICTURE parameters: refer to section 5.4.3, 1)
•WHITE BALANCE parameters: refer to section 5.4.3, 2)
•SCREEN parameters: refer to section 5.4.3, 3)
]
]
Screen 1
MENU | – – |
PICTURE |
|
WHITE BAL. |
|
SCREEN |
|
SIDE MASK |
|
OPTION 1 |
|
OPTION 2 |
|
SUB VOLUME |
|
3ALL DEFAULT |
|
|
|
Screen 2
ALL DEFAULT | – – |
ALL DEFAULT ? | |
YES 2 | NO |
Move the cursor to “NO” and press the SET button to return to screen 1 with remaining the adjustment values.
(NOTE) The following items may not be initialized. Integrator mode:
•SIDE MASK
•OPTION 1 (all)
•OPTION 2 (all)
•SUB VOLUME Menu mode:
•POWER SAVE
•SETUP (all)
125
