Installation of the Attachment Stand

4.3 Installation of the Attachment Stand

1. Make sure to secure the attachment stand to the 4. Insert the unit into the stand. display platform using M8 bolts (commercially

available) 25 mm longer than the thickness of the platform.

Front

Rear

110

2. Insert the supplied washer into the stand.

5. Tighten the bolt against the washer so as to secure the unit.

3. Remove the main unit's A and A' hole rivets using a screwdriver or coin.

Use a 6 mm hexagonal

wrench to tighten the bolt.

The unit weighs 40.3 kg., and its thinness makes it unstable. Therefore, unpacking CAUTION and installation should be performed by

two or more persons.

AA

49

Page 49
Image 49
Pioneer 502MX technical manual Installation of the Attachment Stand