Pioneer 502MX ~ Control IN/OUT terminals, RS 232C terminal, @ Audio Input Stereo mini jack

Controls and Connectors

~CONTROL IN/OUT terminals

For connection to Pioneer products that have the Îmark. If you connect a CONTROL (If CONTROL connection is carried out) then you can carry out system control of the display.

(NOTE) This product does not support RU-V107 wired remote control units.

!RS 232C terminal

Used to make adjustments from PC. (Conforms to EIA- 232-F.)

(Refer to 5.5 RS-232C Adjustment Mode.)

@AUDIO INPUT (Stereo mini jack)

Audio input for use when the picture input uses INPUT 3 or INPUT 4. Connect to the audio output terminal of the device that is connected to INPUT 3 or INPUT 4 of the display.

#AUDIO INPUT

Audio input for use when the image input uses INPUT 1 or INPUT 2. Connect to the audio output terminal of the device that is connected to INPUT 1 or INPUT 2 of the display.

INPUT 4

$INPUT 4 input terminal

Used to input an analog RGB signal or a component picture signal.

(NOTE) Also supports Green on Sync.

This terminal supports Microsoft Plug & Play (VESA DDC 1/2B).

%INPUT 4 output terminal

Signals fed to the INPUT 4 input terminal ($) are output from this terminal. No signal is sent when power is switched off, or in standby status.

(NOTE) When connecting this unit, take a total of five other units as the standard number that can be set to receive input from it.

However, when inputting/outputting to/ from separate sync or composite sync, the source sync level at the end terminal must be 2.2 kΩ, and over 4.8 Vp-p.

INPUT 3

^G(Y)/B(CB/PB)/R(CR/PR)

Receives signals from RGB or video hardware. (NOTE) Also supports Green on Sync.

&HD (H/V SYNC)

Receives signals of HD, and H/V Sync.

*VD

Receives a VD signal.

(Sync Signal Impedance switch

Used to switch impedance for items & and *.

INPUT 2

)S-VIDEO input terminal

_Y/C Separate Video Input terminal

Receives signals from the Y/C separate video.

(Supports S2 output.)

(NOTE) Don't connect the S-jack and the BNC terminal at the same time. Doing so will result in system malfunctions or breakdown.

INPUT 1

+Video Input terminal

Outputs signals received by the video input terminal.

¡Video Output terminal

Video input terminal (+) are output from this terminal. Will not output when the power is off or in standby status.

(NOTE) When connecting this unit, take a total of five other units as the standard number that can be set to receive input from it.

™Main Power switch

Turns the main power on or off.

£AC INLET

Using the power cord accessory, connects to the AC

power source.

¢SPEAKER

Output terminal for a left-hand external speaker. Connected to speakers of 8 to 16Ω inpedance.

11