Quadra-Fire CUMBGAP-MBK, CUMPGAP-PMH I.Optional Blower Operating Instructions, J. Opacity Smoke

R

Cumberland Gap Wood Stove

WARNING

Fire Risk.

•DO NOT BURN GARBAGE OR FLAMMABLE FLUIDS SUCH AS GASOLINE, NAPTHA OR ENGINE OIl.

•Do NOT burn treated wood or wood with salt (driftwood).

•May generate carbon monoxide if burn material other than wood.

May result in illness or possible death.

WARNING

Fire Risk.

Keep combustible materials, gasoline and other flammable vapors and liquids clear of appliance.

•Do NOT store flammable materials in the appliance’s vicinity.

•DO NOT USE GASOLINE, LANTERN FUEL, KEROSENE, CHARCOAL LIGHTER FLUID OR SIMILAR LIQUIDS TO START OR “FRESHEN UP” A FIRE IN THIS HEATER.

•Keep all such liquids well away from the heater while it is in use.

•Combustible materials may ignite.

CAUTION

Odors and vapors released during initial operation.

•Curing of high temperature paint.

•Open windows for air circulation.

Odors may be irritating to sensitive individuals.

NOTE:

•Build fire on brick firebox floor.

•Do NOT use grates, andirons or other methods to support

fuel.

It will averserly affect emissions.

I.Optional Blower Operating Instructions

1.Initial (cold) start-up: Leave blower off until your stove is hot and a good coalbed is established. The blower may be turned on approximately 30 minutes after a good coalbed is established.

2.High burn setting: The blower may be left on through- out the burn at your desired setting.

3.Medium burn settings: The blower should be left off until a good burn is established, then turned on at your desired setting.

4.Low burn setting: The blower tends to cool off the stove. Leave blower off until burn is well established. Then turn on at your desired rate.

5.The highest blower speed is obtained by turning the speed control on and then adjusting counterclockwise towards "OFF" as far as possible without turning the blower off. For a low blower speed, turn the control knob clockwise as far as possible.

J. Opacity (Smoke)

Opacity is the measure of how cleanly your appliance is burning.

Opacity is measured in percent:

•100% opacity is when an object is totally obscured by the smoke column from a chimney, and

•0% opacity means that no smoke column can be seen.

As you become familiar with your appliance, you should peri- odically check the opacity. This will allow you to know how to burn as nearly smoke-free as possible (goal of 0% opacity).

WARNING !

•The outside surfaces of this unit will become extremely hot during use.

•If this appliance is in a high traffic area or children may be near it is recommended that you purchase a decorative bar- rior to go in front of the appliance.

•Always keep children away while it is operating

•Do not let anyone operate this appliance unless they are familiar with these operation instructions.

November 5, 2010 7006-188G Page 29