11 Gas Information
A. Fuel Conversion
•Make sure the appliance is compatible with available gas types.
•Conversions must be made by a qualified service technician using Hearth & Home Technologies speci ed and approved parts.
Converting to LP Gas
Note: Gas conversions should only be performed by a quali ed service person, and/or where required by state and local codes, licensed installer/service technician. In the Commonwealth of Massachusetts, installation must be performed by a licensed plumber or gas tter.
Figure 11.2 Remove Burner Screws
Kit contents:
Pilot injector #35
Burner ori ce
Red pin
Conversion Label
Tools Required:
#2 phillips screwdriver
Straight screwdriver
5/32 allen wrench
3/8 & 11/16 wrenches
•Using a 3/8 wrench, unscrew and remove rear ori ce and discard. See Figure 11.3.
•Turn control knob on the valve to OFF position.
•Remove glass assembly (see Figure 14.A)
•(Remove logs, grate, and ember bed if already installed.)
•Remove 2 screws holding pilot bracket to burner. See Figure 11.1.
Figure 11.3 Remove Burner Ori ce
• Unscrew and remove front ori ce #46 and install in rear.
• Install new ori ce #56 in front.
• Open air shutters to fully open. See Figure 11.4.
• Replace burner and screws holding it in place.
Figure 11.1 Remove Pilot Screws
•Remove 4 screws holding Burner in place and remove burner. See Figure 11.2.
Figure 11.4 Adjusting Air Shutter
46 |