•Advance the SET temperature on the transmitter to a temperature of at least 2° F (1° C) above the ROOM temperature displayed on the LCD screen and the system ame will ignite.
•Set the SET temperature to at least 2° F (1° C) below the room temperature and the system ame will extinguish. Thereafter, it should continue to cycle on and off thermostatically approximately every two minutes as the ROOM temperature changes, but only when the temperature differential between ROOM and SET temperatures differs at least 2° F (1° C). The 2° F differential is the factory setting.
Timer Operation
The countdown timer will operate in either the manual ON or THERMO mode. Once the replace system is in an operating mode, set the countdown timer to turn off in 15 minutes. The timer function will allow operation to contin- ue until the “countdown time” on the LCD screen expires. After 15 minutes elapse, the system should turn off.
General Information
Transmitter Wall Bracket
The transmitter can be hung on a wall using the bracket provided. Locate the bracket on an inside wall suf ciently far away from direct sources of heat such as a replace, incandescent lighting, or sunlight so it detects ambi- ent room temperatures, not a single heat source. If the bracket is installed on a solid wood wall, drill 1/8” pilot holes and install with the screws provided. If it is installed on a plaster/wallboard wall, rst drill two 1/4” holes into the wall, then use a hammer to tap in the two plastic wall anchors ush with the wall, then install the screws provided.
Battery Life
Life expectancy of the batteries in the transmitter should be at least 12 months. Check batteries annually. When the transmitter no longer operates the remote receiver from a distance it did previously (i.e., the transmitter’s range has decreased) the batteries should be checked.
Speci cations
Batteries: Transmitter - 3V 2 ea.; AAA 1.5V, Alkaline Remote -
Operating Frequency: 303.8 MHZ
FCC ID No.’s: Transmitter - K9L300ITX Receiver - K9L3003RX
Canadian ISC ID No.’s: Transmitter - 2439 102 760 Receiver - 2439 102 760A
H. Before Lighting Fireplace
Before operating this replace for the rst time, have a quali ed service technician:
•Verify all shipping materials have been removed from inside and/or underneath the rebox.
•Review proper placement of logs, rockwool and/or other decorative materials.
•Check the wiring.
•Check the air shutter adjustment.
•Ensure that there are no gas leaks.
•Ensure that the glass is sealed and in the proper position and that the integral barrier is in place.
WARNING! Risk of Fire or Asphyxiation! DO NOT oper-
ate replace with xed glass assembly removed.
16 |