C. Clear Space
WARNING! DO NOT place combustible objects in front of the replace or block louvers. High temperatures may start a re. See Figure 2.2.
Avoid placing candles and other
| Clear Space |
| 3 ft (0.91 m) |
| in front of |
| appliance |
Figure 2.2 | Clear Space |
D. Decorative Doors and Fronts
WARNING! Risk of Fire! Install ONLY doors or fronts approved by Hearth & Home Technologies. Unapproved doors or fronts may cause replace to overheat.
This appliance requires the installation of a decorative front with an integral barrier to prevent direct contact with the xed glass panel. Do NOT operate the appliance with the barrier removed.
Contact your dealer or Hearth & Home Technologies if the barrier is not present or help is needed to properly install one.
For more information refer to the instructions supplied with your decorative door or front.
E. Fixed Glass Assembly
See Section 14.A.
F. Dashboard Control
Figure 2.3 Dashboard Control
Valve Control
This knob is used to control the gas to the appliance and for starting the pilot. There are three positions, ON, OFF, PILOT. The indicator on the valve indicates the position of the knob.
Pilot Ignitor
This unit is equipped with an electronic ignitor for the pilot. When the valve control knob is turned to the PILOT position and fully depressed, the ignitor will begin spark- ing and light the pilot. After the pilot is lit, release the knob slightly to stop the ignitor from sparking but continue holding the knob in for 30 seconds to establish the pilot. Release the knob and the pilot should stay lit.
Rear Burner Switch
The rear burner can be shut off completely with the switch, allowing the front burner to operate in either high or low mode for limited heat output.
10 |
