Chapter 5 Running Diagnostic Programs
Running the Move Location Test
94 Sun StorEdge™ L25 Tape Library and Sun StorEdge™ L100 Tape Library User’s Guide
6Press the Up and Down buttons to select the destination for the
robotic hand.
7Press Select.
The GUI displays the Diag: Move Location screen, which
prompts you to set the cycle count (see figure55). The
rightmost number is highlighted.
Figure 55 Diag: Move
Location Screen
8Press the Up and Down buttons to change the highlighted
number.
9Press Left to move the highlight to the next number.
10 Repeat steps 8 and 9 as necessary until the desired cycle count
number is displayed.
11 Press Right until the cursor is all the way to the right and the
Select button appears.
12 Press Select to set the cycle count, or press Cancel to return to
the Diags: General screen without running the Move Location
test.
Note: Setting the cycle count to 0000 causes the test to run
continuously.