Connecting an Optional Preview Monitor

When you copy DV to DV, there are three ways to connect a preview monitor.

Method A: If an analog output device is not connected to the Hollywood DV-Bridge during the conversion process, connect the monitor as follows.

1.Connect an RCA video cable (yellow) or S-Video cable (black) from the Video Out con- nector on the back of the Hollywood DV-Bridge to the corresponding Video In connec- tor on the TV monitor.

2.Connect an RCA audio cable (red and white) from the Audio Out connector on the back of the Hollywood DV-Bridge to the Audio In connector on the monitor.

Note: Your audio cable may have separate connectors for left and right, or the connec- tors might be joined as shown in the illustration below. Remember that you will need to use a Y-adapter if the monitor only supports mono input.

Hollywood DV-Bridge

RCA Video Out

RCA Video In

Or

 

S-Video Out

S-Video In

Audio Out

Audio In

To AC Power)

Back

TV

Optional

Preview Monitor

IMPORTANT: Make sure that the monitor is set up properly to receive a video signal. It might need to be set to “Line In,” “L1,” “L2,” “Aux” or a similar channel. Check the monitor’s documentation for specific details.

Hollywood DV-Bridge User’s Guide • Using Hollywood DV-Bridge Without a Computer • Page 57

Page 57
Image 57
RCA Hollywood DV-Bridge manual Connecting an Optional Preview Monitor