RCA Hollywood DV-Bridge manual Analog Camcorder or VCR Optional Preview Monitor

Method B: If an analog output device is connected during the conversion (for example, if you always leave an output device connected for convenience), you can connect the mon- itor to the output device. The procedure is the same as described above, except that the monitor is connected to the analog output device instead of directly to the Hollywood DV- Bridge. If your monitor does not have the types of connections described above, you may be able to connect the monitor to an output device such as a VCR by using a coaxial cable.

Method B results in the configuration shown below.

Analog Camcorder or VCR

Optional Preview Monitor

RCA Video Out RCA Video In

	Or
S-Video Out	S-Video In
Audio Out	Audio In

(To AC Power)

Back

VHS

RCA Video Out RCA Video In

	Or
S-Video Out	S-Video In
Audio Out	Audio In
	OR
Coaxial Out	Coaxial In

TV

Note: The output analog camcorder or VCR shown in the above illustration is not required for the analog-to-DV conversion procedure. Method B is provided for your convenience in case you have an analog output device attached.

IMPORTANT: Make sure that the camcorder or VCR and monitor are set up properly to receive a video signal. It may be necessary to set a camcorder to VTR mode, while a VCR or monitor might need to be set to “Line In,” “L1,” “L2,” “Aux” or a similar channel. Or, if a monitor is connected to a VCR with a coaxial cable, you might need to set the monitor to channel 3 or 4. Check each device’s documentation for specific details.

Method C: Connect the TV monitor to the analog output connectors on the DV camcorder or VCR, as shown below.

Hollywood DV-Bridge

DV Camcorder or DV VCR

TV

Optional

Preview Monitor

RCA Video In	RCA Video Out
Or
S-Video In	S-Video Out
Audio In	Audio Out
OR
Coaxial In	Coaxial Out

VHS

DV In DV Out

Front

Hollywood DV-Bridge User’s Guide • Using Hollywood DV-Bridge Without a Computer • Page 46