RCA Hollywood DV-Bridge manual DV Output Configurations

DV Output Configurations

When outputting DV, there are two additional methods for connecting a preview monitor.

Method A: If the Hollywood DV-Bridge is not connected for video output to an analog device, connect the TV monitor as follows.

1.Connect an RCA video cable (yellow) or S-Video cable (black) from the Video Out con- nector on the back of the Hollywood DV-Bridge to the Video In connector on the TV monitor.

2.Connect an RCA audio cable (red and white) from the Audio Out connector on the back of the Hollywood DV-Bridge to the Audio In connector on the monitor.

Note: Your audio cable may have separate connectors for left and right, or the connec- tors might be joined as shown in the illustration below. Remember that you will need to use a Y-adapter if the monitor only supports mono input.

Hollywood DV-Bridge

RCA Video Out	RCA Video In
Or
S-Video Out	S-Video In
Audio Out	Audio In

TV

(To AC Power)	Optional
	Preview Monitor
	Back

IMPORTANT: Make sure that the monitor is set up properly to receive a video signal. It might need to be set to “Line In,” “L1,” “L2,” “Aux” or a similar channel. Check the monitor’s documentation for specific details.

Hollywood DV-Bridge User’s Guide • Using Hollywood DV-Bridge With a PC • Page 28